Find Your Machine
Send a message

I’m Most Interested In *

Container Type

Equipment Type

Target Fill Speed

Target Fill Size

Target Accurcy

inside banner

Daily maintenance method of automatic auger filling machine

   If we do not maintain the automatic auger filling machine properly, it will reduce the service life of the machine. In order to keep the automatic auger filling machine in good working conditi

Daily maintenance method of automatic auger filling machine

Mar Mon,2021 Daily maintenance method of automatic auger filling machine
   If we do not maintain the automatic auger filling machine properly, it will reduce the service life of the machine. In order to keep the automatic auger filling machine in good working condition, we should pay attention to the maintenance of the machine in these aspects.

      Daily maintenance method:

Before starting the machine every day, check whether there is any problem with the power supply of the automatic auger filling machine, and check whether the insulation layer outside the power supply is damaged or whether the cable plug has fallen out. After confirming that there are no problems, start the operation of the equipment. It is the maintenance of the automatic auger filling machine and the safety consideration of the operator himself. Add lubricating oil in time to make the machine run flexibly and reduce machine wear.

      Do a good job in equipment sanitation work, maintain the sanitation of the material contact parts, and let the operator pay more attention to whether the motor is running or not running smoothly when the motor is running. If there is any, stop working and start troubleshooting , And then start working again after the ending failure. Give the motor a little lubricating oil every once in a while. If you work for a long time every day, the time interval should be smaller.

   This machine has not been used for a long time. After use, the machine should be cleaned to avoid some residual materials from corroding the machine. Then apply anti-rust oil on the machine and cover it with a cloth. The equipment is not used frequently and needs to be sealed after each use to prevent impurities from appearing in the next use. When the machine is running, the noise may be caused by insufficient gear oil or misalignment of the gears, which needs to be repaired in time.